For the ultimate in rigid cheek weld durability in the field, while only adding 47 grams to your rifle. We offer our ACCU long range precision rifle cheek rest, which will give you the proper cheek weld for mounted optics on your precision target or hunting rifle.
This FDM 3D printed cheek rest has been manufactured to add stability while decreasing weight due to the innovative geometric internal structure. Black in colour and 16mm in height, these cheek rests are designed to be setup and have the front section slide away to allow you to install/remove your bolt and allow for cleaning. This allows you to keep the cheek rest in the perfect resting check position since there isn't a need to remove the cheek rest for bolt installation and removal.
See other listings if you would like the following heights:13mm, 18mm.
The photo's illustrate the cheek rest on a Tikka T3, however they will fit a wide array of stocks including Tikka TX3, Sako, Remington, Marlin. I’ve even added them to Choate and ATI fiberforce 10/22.
- FDM 3D Printed
- Rigid but ultra light weight - 47grams!!
- 16mm height, 137mm Length, 34.5mm width.
(see other listings if you would like the following heights:
Most people like the 16mm height.
- Short term install with supplied tape. Long term install with screw.
- Leave in place while installing/removing bolt and when cleaning.
Fitted following rifles with success:
** rifle, cleaning rod and cheek rest cover not included **
$3 Delivery NZ wide